Smart Energy Meter / Smart Plug / Mains Switch with more than 1 Million Switch Cycles

ZBS-110V2 - ZigBee
MBS-110V2 - wireless M-Bus


  • Measurement of voltage, current, frequency, power and electrical work as well as various power factors
  • Energy saving through switching standard and standby power consumption
  • Accurate relay switching: Switching on at voltage zero crossing ("ZX-U"), switching off at current zero crossing ("ZX-I")
  • pikkerton SART-Technology
  • Switching of inductive and capacitive loads
  • Signaling of mains supply, detection of shortest outages & voltage drops
  • Detection of overload situations
  • Firmware upgradable via ZigBee network
  • OGEMA-Driver available (Open Gateway Energy Management Alliance)
  • Connector for external temperature sensors (/T)
  • Local control algorithms for temperature control of connected devices (e.g. fridges, etc.)
  • IP44 chassis (/F)

Technical data:

Standards ./.
LxWxH [mm] 96x63x49
Material ABS, black
IP Rating IP20, opt. IP44 (/"F")
Power Supply
External Voltage 90.250 VAC
External Connector CEE 7/7
Internal ./.
Typ. Power Consumption <0.5 W
Interfaces / Sensors
Relay Relay Output
CEE 7/4
nominal load 10 A / 250 VAC, 2500 VA
max. load 16 A / 4000 VA
switch capacity max. 35 μF bei 230 VAC
switch cycles: mech. 10^7
normal operation: 1 Mio.
Electrical Meter Voltage, Current, Frequency, Power and electrical Work Mains Quality analysis ("/NQ" option)

<2% active energy
<2% RMS metering
Temperature Sensors 2x external Connectors for digital calibrated Sensors ICs on foil cable ("/T")
Operating Temperature 0..35 °C
Operating Rel. Humidity non-condensing
Storage -20/+60°C
Safety / EMC / RF CE, VDE
Tariff Information 9028 3011

Communication ZigBee
Protocol / Frequency IEEE 802.15.4 ZigBee,  max. 250 KBit/s, ISM 2.4 GHz
Role / Mode Router
Max. direct joined end nodes 20, use further routers for additional end nodes
Transmit Power +8 dBm (6 mW)
Receive Sensitivity -102 dBm
Antenna Internal, PCB
Encryption AES128

Communication Wireless M-Bus (MBS-)
Protocol / Frequency OMS / Wireless M-Bus 868 MHz
Role / Mode End-Node
Operation Mode: T1
TX Cycle:
60s mains powered
300s battery powered
Transmit Power +10 dBm
Receive Sensitivity -112 dBm
Antenna Internal, PCB

Communication Wireless LAN
Protocol / Frequency IEEE 802.11 b/g/n (2,4-2,5 GHz)
Role / Mode Configuration: Access Point
Operation: Client
Transmit Power max. +20 dBm
Receive Sensitivity max. -98 dBm
Antenna Internal, PCB
Encryption WEP, WPA, WPA2

Ordering / Options:

  • 75ZBS110V2 Energy Meter
  • 75ZBS110V2/NQ upgrade for mains quality analysis
  • 75ZBS110V2/T with 2 connectors for external temperature sensors
  • 75ZBS110V2/F IP44 protected (not with /T)
  • 75ZBS110V2*/P Smart Energy Meter in several options with  pro module for wider range
      - Transmit power: +10 dBm (+10 mW)
      - Receiver sensitivity: -102 dBm
  • 75ZBS110V2/UK BS system (Great Britain)
  • 75ZBS110V2/US NEMA system (USA)
  • 75ZBS110V2/CH SEV system (Switzerland)
  • 73ZBS110V2T1 external temperture sensor with 2.5m cabel length

Date: 06/04/13, Version: 2.0


pikkerton GmbH
Wohlrabedamm 16
D-13629 Berlin
Tel.: +49 30 3300724-0
Email to pikkerton
Used Technologies

International Plug Systems

Relay contacts without SART
Relays´ contacts without SART technology

Relay contacts with SART
Relays´ contacts with SART technology

T-Sensor for ZBS-110V2

Typical Applications
  • Metering for Energy Provider and Customers
  • Sub-Metering
  • Smart-Energy / Smart-Grid
  • Control of fridges / cooling units / water heaters
  • Remote Control and Management of devices
  • Standby Power Management
  • Mains quality analysis
  • Industrial Automation
  • Home Automation

Literature / Download
...can be found in Service & Support


print datasheet

Contact  Imprint  | pikkerton GmbH - Phone: +49.30.3300724-0